Anton/Bauer LOGIC Series User Manual download pdf (Page 12)

- 8 -

OVER-DISCHARGED BATTERIES

An “over-discharged” voltage state is caused by leaving a battery

operated device unattended and allowing the battery to drain beyond the

low voltage warning point of the equipment and/or the “Flashing 15

minute segment” indication on the LCD of the DIGITAL battery.

Low voltage over-discharged batteries can also be caused by allowing

batteries to remain off the charger for extended periods. Returning

batteries to the Logic Series Lifesaver Charger as soon as possible after

use, and leaving batteries in the Lifesaver mode until just prior to using

will avoid this type of over-discharge condition.

A battery that has been inadvertently allowed to become over-discharged

will automatically trigger a special rejuvenation routine contained in all

Anton/Bauer Logic Series Chargers. In such cases the red/green

alternating LED’s, on the charger, indicate that the automatic rejuvenation

cycle is bringing the battery back up to a safe charging voltage. When the

Logic Series Charger verifies there are no thermal violations, it will begin

a complete charge cycle (Red flashing LED).

In the extreme case that a battery is over-discharged, the rejuvenation

charge routine will not be initiated by the charger until all other batteries

have completed their fast charge routines. Therefore, an extremely over-

discharged battery can be installed on a Logic Series Charger without the

charger indicating recognition.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

No comments

Anton/Bauer LOGIC Series User Manual Page 12