Anton/Bauer LOGIC Series User Manual download pdf (Page 15)

- 11 -

RealTime Display Indications

• When the battery is being charged no remaining runtime is displayed.

• Remaining run time is calculated using the present available battery

capacity and a constantly updated accurate measurement of the

present load on the battery.

• If no load is detected, or if the battery is removed from the charger

before any discharge load is applied, the default assumed power for

remaining run time calculations is 20 Watts.

• When the battery determines that a load is attached, remaining run

time will be calculated based on that load and the time remaining will

be updated.

• The battery will “learn” this new load and retain that load information

in non-volatile memory. If the battery is removed from the camera it

will retain this information for 30 minutes or until it is returned to the

charger or sees a new load. After 30 minutes the battery will return to

the default load of 20 watts.

• OVERCURRENT INDICATION

If the battery is subjected to a load that exceeds specifications all

status icons on the LCD will flash at a once per second rate. When

the over-load condition is removed, the display will return to normal.

• When the battery is completely discharged the LCD will flash the 15

minute icon until the battery is returned to a charger.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

No comments

Anton/Bauer LOGIC Series User Manual Page 15